These are the Support Forums for FSUIPC and related products.

These forums replace the old support forums which have been running for 20+ years. The old forums contain a wealth of information on all FSUIPC products, but are now no longer available.

Please note that you will need to Register and Login to post for support, and also to download attachments. You can view these forums without registering.

Support is also available via Discord. Please use the following invite link to join the FSUIPC Discord server:
https://discord.gg/zjwUTrxmmE

Notifications

Clear all

[Solved] Increase/Decrease command for Input Event

MD82 · 2026-08-18T14:47:01Z

Hello, I'm trying my best to find out the bindings for the new 707. I have managed to sort out quite some things. However, I'm stuck on the A/P Pitch Wheel. From Dev. Mode I can see that the wheel has 3 Input Events (..._Set, ..._Inc and ..._Dec). When I access the Input Events in FSUIPC, I can see the same initial name of the event "AP PITCH CONTROL WHEEL 1/2". If I manipulate the wheel in the VC, the values change in units of 10° up or down all the way around 360° (since it's a round wheel). When I assign this to a button, in FSUIPC and I set a parameter, it seems that it SETS a wheel position. (e.g. Parameter 1 gives 50°, Parameter 3.6 gives 180°, Parameter 0 gives 0°, etc., etc.) Since there is no separate Input Event to distinguish between increasing or decreasing, is there a way to still achieve that using this input event? Thanks, Xander

Page 3 / 3 Prev

Posts: 12

MD82

Registered

Topic starter

August 19, 2026 6:23 pm

(@md82)

Joined: 5 months ago

You're the best. I'll get back on the horse tomorrow!

Posts: 354

FSUIPC

Admin

August 19, 2026 6:25 pm

(@fsuipc)

Joined: 1 year ago

Ok, but due to travels and other commitments, after today I will be unavailable until Monday or so (most probably).

Posts: 12

MD82

Registered

Topic starter

August 19, 2026 6:28 pm

(@md82)

Joined: 5 months ago

No worries at all. I don't think there's anything you can tell me that you haven't already. Now it's just a case of my putting in the elbow grease.

This post was modified 1 week ago by MD82

Posts: 12

MD82

Registered

Topic starter

August 19, 2026 6:47 pm

(@md82)

Joined: 5 months ago

So, I got back on the horse. Found the Calculator Code working and added the following to my events:

//Working Title/707-320C/Autoflight
Autopilot Pitch Control Increase#1 (>B:AP_PITCH_CTRL_WHEEL_1_INC)
Autopilot Pitch Control Decrease#1 (>B:AP_PITCH_CTRL_WHEEL_1_DEC)

As a result, my pitch control wheel works!!! Thanks for your patience.

SOLVED

This post was modified 1 week ago 2 times by MD82

This post was modified 1 week ago 2 times by FSUIPC

Posts: 354

FSUIPC

Admin

August 19, 2026 6:49 pm

(@fsuipc)

Joined: 1 year ago

Great - glad you finally sussed it!

Page 3 / 3 Prev