These are the Support Forums for FSUIPC and related products.

These forums replace the old support forums which have been running for 20+ years. The old forums contain a wealth of information on all FSUIPC products, but are now no longer available.

Please note that you will need to Register and Login to post for support, and also to download attachments. You can view these forums without registering.

Support is also available via Discord. Please use the following invite link to join the FSUIPC Discord server:
https://discord.gg/zjwUTrxmmE

Notifications
Clear all

Convert PFC throttle quadrant to USB from serial

(@bellah1w)
Posts: 7
Registered
Topic starter
 

PFC - 6 Linear rheostat pot board Conversion to a usb Digital voltage potentiometer joystick.

###Good news is the linear potentiometers are just one wire connection away to an upgrade to a digital upgrade and so much more accurate with a lot less spikes! Higher Resolution: Bypasses aging PFC controller bit-limits for smoother, precise input processing.####

Brown stripe pot 1

Orange pot 2

Blue stripe pot 3

Blue pot 4

Orange stripe pot 5

green pot 6

Green stripe common/ Ground

(### Pots are ordered 1 - 6 with pot 1 being closest to the RJ 45 plug)

Use an ethernet cable with an RJ 45 plug and strip the coloured wires as above .

Buy a Leo Bodnar 836 A Board .

On the three pins analogue joystick connectors - solder a line of solder on the back to join up all the ground pins ( as you only need one pin from the board to ground all the linear pot out puts .

Solder the the coloured wires
to the middle pin.

To covert it the potentiometers to digital variable voltage pots all you need to do is solder a new wire on each of the pots 1 - 6 ( choose the pins on each of the 6 pots on the back of the throttle board on the left side , closest to the edge looking towards the RJ 45 plug and match that wire to the coloured wire on the table above and solder to the matching three pin row matching the ethernet cable colour to the pot number as above .

Keep in mind as you have soldered the ground pins at the back together only the first pin will need the ground wire coming from the PFC throttle board.

So you will have 1 row of three pins and 5 rows of 2.

Windows will see it as a normal windows joystick and you can then just use it through FSUIPC as normal without using the pfc serial driver .

 


 
Posted : November 9, 2026 4:20 am
Topic Tags